Neal Spalding
~ FLINT WORKS ~
| (click on picture to enlarge) | |
|
|
ADENA
5 -3/4 inch |
|
|
|
THEBES SET Set Thebes points, Both points are around the 3 -3/4 in
mark, made from Burlington chert. |
|
|
 |
ADENA
This one is a
8-1/2 inch adena made from keokuk
chert. $75.00 |
|
|
 |
FLINT KNIFE This one is a 7-5/8 inch knife made out of buffalo river. $55 |
|
|
 |
CLOVIS This one is a 3-7/8 inch clovis
made of keokuk chert. $40
|
|
|
 |
DALTON
This Dalton is
5-1/8 inches and made from flint ridge
material.
$75 |
|
|
 |
ADENA Here is a 7-3/8 keokuck chert adena. $75 |
|
|
 |
PALEO KNIFE This is a 7-1/8 inch paleo knife made out of some high
grade keokuk. $70 |
|
|
 |
LATE ARCHAIC
TYPE This is a random flaked late archaic type made from flint
ridge. If the flaking was better I
would ask for $75 but
asking $50. It is 4-1/2
inches long. |
|
|
 |
TURKEY TAIL Here's a little turkey tail made from Kentucky hornstone. It is 4-1/4 inches. $25 I hate to admit it but I can make
some long thin turkey tails but
I'll never catch up to Jim Spears! His video is real good. |
|
|
 |
CLOVIS
This clovis is 3-1/2
inches and made from keokuk Burlington. $35 |
|
|
 |
CLOVIS
This is a 7-3/8 obsidian clovis. Short fluted
both sides. $80 |
|
|
 |
ST LOUIS CLOVIS Here is a 5-3/4 St, Louis clovis made out of
mahogany obsidian. Fluted one side
only. $40 |
|
|
 |
DALTON,
Re-worked
Not for sale. It is exactly 5 inches and made from burlington or keokuk. |
|
|
 |
STILLWELL
Archaic corner notch.
It is made from Kentucky Hornstone and
is 4-3/4" long. $55 |
|
|
|
|
ST LOUIS CLOVIS
Obsidian St. Louis Clovis. |
Page last updated March 4, 2007